XCP CAN TL Transmit

Transmit queued XCP Messages


The XCP CAN Transport Layer Transmit block connects to a CAN Transmit block to transmit queued XCP messages.

Other Supported Features

The XCP CAN TL Transmit block supports the use of Simulink® Accelerator™ and Rapid Accelerator mode. Using this feature, you can speed up the execution of Simulink models.

For more information on this feature, see the Simulink documentation.

Dialog Box

Use the Block Parameters dialog box to select your XCP CAN Transport Layer Transmit block parameters.

Maximum number of messages

Enter the maximum number of messages the block can transmit. Value must be a positive integer.

Sample time

Specify the sampling time of the block during simulation, which is the simulation time as described by the Simulink documentation. This value defines the frequency at which the XCP CAN Transport Layer block runs during simulation. If the block is inside a triggered subsystem or to inherit sample time, you can specify –1 as your sample time. You can also specify a MATLAB® variable for sample time. The default value is 0.01 (in seconds).

Was this topic helpful?