PCL-711B Analog Input block (not recommended)
Simulink® Real-Time™ Library of Drivers No Longer Recommended for Use
Block Output Data Type
Enter numbers between 1 and 8. For example, to use the first and second analog output (A/D) channels, enter
Number the channels beginning with 1 even if this board manufacturer starts numbering the channels with 0.
Enter a range code for each of the channels in the channel vector. The range vector must be the same length as the channel vector. This board allows the range of each channel to be different.
The following table is a list of the ranges for this driver and the corresponding range codes.
Input Range (V)
-5 to +5
-2.5 to +2.5
-1.25 to +1.25
-0.625 to +0.625
-0.3125 to +0.3125
For example, if the first channel is -5 to +5 volts and the
second channel is
Enter the base sample time or a multiple of the base sample
-1 means sample time is inherited).
Enter the base address of the board. This entry must correspond
to the DIP switch setting on the board. For example, if the DIP switch
setting is 300 (hexadecimal), enter