Analogic AIM12 Analog Input block (not recommended)
Simulink® Real-Time™ Library of Drivers No Longer Recommended for Use
I/O Module Input
Block Input Data Type
Single-ended (16 channels) input mode,
enter a number between 1 and 16 to indicate the first channel to be
Differential (8 channels) input mode,
enter a number between 1 and 8.
This is the last channel to acquire. The number must be greater
than or equal to the first channel. In
Single-ended (16 channels) input
mode, the number must be less than or equal to 16. In
(8 channels) input mode, the number must be less than or
equal to 8.
From the list, select one from the following list of input modes:
Single-ended channels (16 channels)
Differential channels (8 channels)
Check the manufacturer documentation for wiring configurations.
Enter a vector of gain values with one entry for each channel in the range first channel to last channel. Allowable gain settings for the AIM12 are 1, 10, and 100. If you enter a scalar for gain, this value is used for all channels.
Enter the base sample time or a multiple of the base sample
-1 means sample time is inherited).
Enter the base address of the board. This entry must correspond
to the DIP switch setting on the board. For example, if the DIP switch
setting is 300 (hexadecimal), enter