Condor 1553 Encode BC Message block for bus controller (not recommended)
Simulink® Real-Time™ Library of Drivers No Longer Recommended for Use.
To open this library, type
xpcobsoletelib in the Command
This block fills each message for the time step during which the message is sent.
The Create BC Message List block allocates an empty list of message buffers in Simulink Real-Time memory. Use the Encode BC Message block to fill these messages.
Enter the number of the message to encode. Each BC message needs to use a unique message number. This is the place in the list to fill with this message.
From the list, choose a Remote Terminal address 1.
From the list, choose a Remote Terminal sub address 1. Setting this
Send (0) mode command or
(31) mode command disables the Message word
From the list, choose a Remote Terminal address 2. This is not used if
the Direction is
From the list, choose a Remote Terminal sub address 2. This is not
used if the Direction is
If the Sub address 1 is 0 or 31, from the list, choose a mode command.
Specify the number of
uint16 words to send or
From the list, choose the encode direction. Choose from
Specify the minimum amount of time, in microseconds, between messages.
From the list, choose output bus
B that this message will be sent on.
Enter the base sample time or a multiple of the base sample
-1 means sample time is inherited).