Condor PCI-1553 RT Receive block for remote terminal (not recommended)
Simulink® Real-Time™ Library of Drivers No Longer Recommended for Use.
To open this library, type
xpcobsoletelib in the Command
Your model can have multiple Remote Terminal Receive blocks. To help you locate a particular block, the Remote Terminal Receive block displays the channel number and address parameters. The address display has the format:
remote terminal-R-sub address-number of words
Remote terminal — Is the Remote Terminal parameter
R — Indicates receive command
Subaddress — Is the Sub address parameter
Number of words — Is the Number of words to receive parameter
A receive command for RT
1, sub address
3 to receive
2 words has the
From the list of available channels on the board, choose
This channel is initialized for this command stream.
From the list, choose a Remote Terminal from
The remote terminal number configured in RT Send and RT Receive must
match that specified by the corresponding RT Initialize block.
From the list, choose a sub address from
Select the sub address for this message.
Enter the number of 16-bit integers to receive as the data part of this message. This number must be between 1 and 32. The output data vector has the same vector width.
If this Remote Terminal or sub address can be sent messages with different lengths, specify the longest message length for this parameter. You must determine how much length is significant from content.
Select this check box to cause output
Output T returns the time, in microseconds, at which the most recent message was received. The time is measured from the beginning of execution.
Enter the base sample time or a multiple of the base sample
-1 means sample time is inherited).
If only one board of this type is in the target computer, enter
locate the board.
If two or more boards of this type are in the target computer, enter the bus number and the
PCI slot number of the board associated with this driver block. Use the format
To determine the bus number and the PCI slot number, type:
tg = slrt; getPCIInfo(tg, 'installed')