Condor Q104-1553 RT Send

Condor Q104-1553 RT Send block for remote terminal (not recommended)


Simulink® Real-Time™ Library of Drivers No Longer Recommended for Use.

To open this library, type xpcobsoletelib in the Command Window.


A Remote Terminal block sends data only if it receives a transmit command from the Bus Controller. The Remote Terminal block prepares the board for the next transmit command. It gets its channel, Remote Terminal number, and sub address from the Initialize and RT Initialize blocks.

The data vector signal input to this block is copied to the board message buffer that corresponds to the specified address. The input data vector must have the same length as specified in the Number of words to send parameter. The input vector can be either 16-bit or 32-bit signed or unsigned data. The block sends only the bottom 16 bits of each element.

Your model can have multiple Remote Terminal Send blocks. To help you locate a particular block, the Remote Terminal Send block displays the number and address parameters in the following format:

remote terminal-T-sub address-number of words
  • Remote terminal — Is the Remote Terminal parameter

  • T — Indicates transmit (or send) command

  • Subaddress — Is the Sub address parameter

  • Number of words — Is the Number of words to receive parameter

  • A transmit command for RT 1, sub address 3 to send 2 words has the layout 1-T-3-2.

Block Parameters


From the list of available channels on the board, choose 1, 2, 3, or 4. This channel is initialized for this command stream.

Remote Terminal

From the list, choose a Remote Terminal from 0 to 31. The remote terminal number configured in RT Send and RT Receive must match that specified by the corresponding RT Initialize block.

Sub address

From the list, choose a sub address from 0 to 31. Select the sub address for this message.

Number of words to send

Enter the number of 16-bit integers to send as the data part of this message. This number must be between 1 and 32. The input data vector must have the same vector width.

Sample time

Enter the base sample time or a multiple of the base sample time (-1 means sample time is inherited).

Base address

Enter the base address of the board. This entry must correspond to the DIP switch setting on the board. For example, if the DIP switch setting is 300 (hexadecimal), enter 0x300.

Was this topic helpful?