Contec PIO-32/32F(PCI) Digital Output block
Simulink® Real-Time™ Library for Contec
I/O Module Output
Block Input Data Type
< 0.5 = TTL low
If you select
serial, the block is configured to
accept up to 32 one-bit input channels for output. If you select
the block is configured to accept a single 32-bit channel and the
channel vector parameter is unavailable.
serial I/O format, enter a vector of
numbers to specify the output channels. For example, to use the first
and third digital output channels, enter
The channel numbers can occur in arbitrary order, but the numbers must be in the range 1 to 32.
The reset vector controls the behavior of the channel at model
termination. Enter a scalar or a vector that is the same length as
the channel vector. If you specify a scalar value, that setting is
replicated over the channel vector. If you specify a value of
the corresponding channel is reset to the value specified in the initial
value vector. If you specify a value of
channel remains at the last value attained while the model was running.
The initial value vector contains the initial voltage values
(0 or 1) for the output channels. Enter a scalar or a vector that
is the same length as the channel vector. If you specify a scalar
value, that value is replicated as the initial value over the channel
vector. The channels are set to the initial values between the time
the model is downloaded and the time it is started. If you selected
format, the values can be in the form [hex2dec('ffffffff')].
Enter the base sample time or a multiple of the base sample
-1 means sample time is inherited).
If only one board of this type is in the target computer, enter
locate the board.
If two or more boards of this type are in the target computer,
enter the bus number and the PCI slot number of the board associated
with this driver block. Use the format
To determine the bus number and the PCI slot number, type:
tg = slrt; getPCIInfo(tg, 'installed')