Garnet-MM Digital Output block (not recommended)
Simulink® Real-Time™ Library of Drivers No Longer Recommended for Use
Each chip port of the Garnet-MM board can be configured independently for either input or output. Use a separate driver block for each port. Select the digital input driver block for a given port to configure the port for input.
I/O Module Input
Block Output Data Type
TTL low = 0.0
Enter numbers between 1 and 8 to select the digital output lines used with this port. This driver allows the selection of individual digital output lines in arbitrary order. The number of elements defines the number of digital lines used.
For example, to use all the digital outputs for the current port, enter
Number the lines beginning with 1 even if this board manufacturer starts numbering the lines with 0.
From the list choose
The reset vector controls the behavior of the channel at model
termination. Enter a scalar or a vector that is the same length as
the channel vector. If you specify a scalar value, that setting is
replicated over the channel vector. If you specify a value of
the corresponding channel is reset to the value specified in the initial
value vector. If you specify a value of
channel remains at the last value attained while the model was running.
The initial value vector contains the initial values (
of the output channels. Enter a scalar or a vector that is the same
length as the channel vector. If you enter a scalar, that value is
replicated as the initial value over the channel vector. The channels
are set to these initial values between the time the model is downloaded
and the time it is started.
From the list choose
Note, only select
1 for the 24 line version of
the Garnet-MM board. Selecting
2 for the 24 line
board does nothing. You can select either
the 48 line version of the board.
Enter the base sample time or a multiple of the base sample
-1 means sample time is inherited).
Enter the base address of the board. This entry must correspond
to the DIP switch setting on the board. For example, if the DIP switch
setting is 300 (hexadecimal), enter