Ruby-MM Digital Output block (not recommended)
Simulink® Real-Time™ Library of Drivers No Longer Recommended for Use
I/O Module Output
Block Input Data Type
< 0.5 = TTL low
Enter numbers between 1 and 8 to select the digital output lines to drive. This driver allows the selection of up to 8 individual digital output lines in arbitrary order. The number of elements defines the number of digital lines used.
For example, to use all of the digital inputs enter
Number the lines beginning with 1 even if this board manufacturer starts numbering lines with 0.
From the Port list, choose either
C. The Port parameter
defines which port is used for this driver block. Each port has a
maximum of 8 digital outputs. One block is required for each port
The reset vector controls the behavior of the channel at model
termination. Enter a scalar or a vector that is the same length as
the channel vector. If you specify a scalar value, that setting is
replicated over the channel vector. If you specify a value of
the corresponding channel is reset to the value specified in the initial
value vector. If you specify a value of
channel remains at the last value attained while the model was running.
The initial value vector contains the initial values (
of the output channels. Enter a scalar or a vector that is the same
length as the channel vector. If you enter a scalar, that value is
replicated as the initial value over the channel vector. The channels
are set to these initial values between the time the model is downloaded
and the time it is started.
Enter the base sample time or a multiple of the base sample
-1 means sample time is inherited).
Enter the base address of the board. This entry must correspond
to the DIP switch setting on the board. For example, if the DIP switch
setting is 300 (hexadecimal), enter
Note: Please consult the Diamond Ruby-MM manufacturer documentation for more information on jumper settings and I/O connections.