CIO-PDISO16 Digital Input block (not recommended)
Simulink® Real-Time™ Library of Drivers No Longer Recommended for Use
The CIO-PDISO16 has two independent connectors. Each connector has 8 digital input lines.
Use a separate driver block for each connector.
I/O Module Input
Block Output Data Type
5 to 24 volts DC/AC
~0 volts = 0.0
Enter a number between 1 and 8 to select the number of digital input lines used with this connector. This driver does not allow the selection of individual digital input lines.
From the list, choose either
1 (nearest to backplate) or
(farthest from backplate) to select the connector used.
Enter the base sample time or a multiple of the base sample
-1 means sample time is inherited).
Enter the base address of the board. It is important that this entry corresponds to the DIP switch settings on the board. For example, if the base address is 300 (hexadecimal), enter
The Wait-State jumper has to be in the off position.
The remaining switch and jumper settings do not influence the running of the Simulink Real-Time software.