PCI-DDA04/12 Digital Output (not recommended)
Simulink® Real-Time™ Library of Drivers No Longer Recommended for Use.
To open this library, type
xpcobsoletelib in the Command
The PCI-DDA04/12 has two 8255 chips (1,2). Each chip has three ports (A,B,C). Each port has a maximum of 8 digital I/O lines that can be configured as inputs or outputs.
Use a separate driver block for each port. To configure the port as output, use the digital output driver block.
I/O Module Output
Block Input Data Type
< 0.5 = TTL low
Enter numbers between 1 and 8 to select the digital output lines used with this port. This driver allows the selection of individual digital output lines in arbitrary order. The number of elements defines the number of digital lines used.
For example, to use all of the digital outputs for one port, enter
Number the lines beginning with 1 even if this board manufacturer numbers the lines beginning with 0.
From the list choose either
C. The I/O board has two
8255 chips with 3 ports. The Port parameter defines
which port of the 8255 chip is used for this driver block. Each port has
a maximum of 8 digital lines that can be configured as inputs or outputs
depending on which driver block is chosen. In each case, one block is
required for each port.
The reset vector controls the behavior of the channel at model
termination. Enter a scalar or a vector that is the same length as
the channel vector. If you specify a scalar value, that setting is
replicated over the channel vector. If you specify a value of
the corresponding channel is reset to the value specified in the initial
value vector. If you specify a value of
channel remains at the last value attained while the model was running.
The initial value vector contains the initial values (
of the output channels. Enter a scalar or a vector that is the same
length as the channel vector. If you enter a scalar, that value is
replicated as the initial value over the channel vector. The channels
are set to these initial values between the time the model is downloaded
and the time it is started.
From the list choose
Chip parameter defines which of the two 8255
chips is used.
Enter the base sample time or a multiple of the base sample
-1 means sample time is inherited).
If only one board of this type is in the target computer, enter
locate the board.
If two or more boards of this type are in the target computer, enter the bus number and the
PCI slot number of the board associated with this driver block. Use the format
To determine the bus number and the PCI slot number, type:
tg = slrt; getPCIInfo(tg, 'installed')