PCI-DIO24 Digital Input (not recommended)
Simulink® Real-Time™ Library of Drivers No Longer Recommended for Use.
To open this library, type
xpcobsoletelib in the Command
The PCI-DIO24 has one 8255 chip with three ports (A,B,C). Each port has a maximum of 8 digital I/O lines that can be configured as inputs or outputs.
Use a separate driver block for each port. To configure the port as input, use the digital input driver block.
I/O Module Input
Block Output Data Type
TTL low = 0.0
Enter numbers between 1 and 8 to select the digital input lines used with this port. This driver allows the selection of individual digital input lines in arbitrary order. The number of elements defines the number of digital lines used.
For example, to use all of the digital inputs for one port, enter
Number the lines beginning with 1 even if this board manufacturer numbers the lines beginning with 0.
From the list choose either
C. The I/O board has an 8255
chip with 3 ports. The Port parameter defines which
port of the 8255 chip is used for this driver block. Each port has a
maximum or 8 digital lines that can be configured as inputs or outputs
depending on which driver block is chosen. In each case, one block is
required for each port.
Enter the base sample time or a multiple of the base sample
-1 means sample time is inherited).
If only one board of this type is in the target computer, enter
locate the board.
If two or more boards of this type are in the target computer, enter the bus number and the
PCI slot number of the board associated with this driver block. Use the format
To determine the bus number and the PCI slot number, type:
tg = slrt; getPCIInfo(tg, 'installed')