PCI-DIO24 Digital Output
Simulink® Real-Time™ Library for Measurement Computing™
The PCI-DIO24 has one 8255 chip with three ports (A,B,C). Each port has a maximum of 8 digital I/O lines that can be configured as inputs or outputs.
Use a separate driver block for each port. By selecting the digital output driver block, the port is configured as output.
I/O Module Output
Block Input Data Type
< 0.5 = TTL low
Enter numbers between 1 and 8 to select the digital output lines used with this port. This driver allows the selection of individual digital output lines in arbitrary order. The number of elements defines the number of digital lines used.
For example, to use all of the digital outputs for one port, enter
Number the lines beginning with 1 even if this board manufacturer numbers the lines beginning with 0.
From the list choose either
C. The I/O board has an 8255 chip with 3 ports.
The Port parameter defines which port of the
8255 chip is used for this driver block. Each port has a maximum or
8 digital lines that can be configured as inputs or outputs depending
on which driver block is chosen. In each case, one block is required
for each port.
The reset vector controls the behavior of the channel at model
termination. Enter a scalar or a vector that is the same length as
the channel vector. If you specify a scalar value, that setting is
replicated over the channel vector. If you specify a value of
the corresponding channel is reset to the value specified in the initial
value vector. If you specify a value of
channel remains at the last value attained while the model was running.
The initial value vector contains the initial values (
of the output channels. Enter a scalar or a vector that is the same
length as the channel vector. If you enter a scalar, that value is
replicated as the initial value over the channel vector. The channels
are set to these initial values between the time the model is downloaded
and the time it is started.
Enter the base sample time or a multiple of the base sample
-1 means sample time is inherited).
If only one board of this type is in the target computer, enter
locate the board.
If two or more boards of this type are in the target computer,
enter the bus number and the PCI slot number of the board associated
with this driver block. Use the format
To determine the bus number and the PCI slot number, type:
tg = slrt; getPCIInfo(tg, 'installed')