PCI-6601 Pulse Generation block (not recommended)
Simulink® Real-Time™ Library of Drivers No Longer Recommended for Use.
To open this library, type
xpcobsoletelib in the Command
The inputs to the block are separate, one for the high count and one for the low count.
From the list, choose one of the following:
These parameters specify the counter(s) to be used with this driver block. In each case, one block is required for each port.
The reference frequency for this board is 20 MHz.
Enter the number of clock ticks the counter should maintain for a high level.
Enter the number of clock ticks the counter should maintain at a low level.
Enter the base sample time or a multiple of the base sample
-1 means sample time is inherited).
If only one board of this type is in the target computer, enter
locate the board.
If two or more boards of this type are in the target computer, enter the bus number and the
PCI slot number of the board associated with this driver block. Use the format
To determine the bus number and the PCI slot number, type:
tg = slrt; getPCIInfo(tg, 'installed')