IP-16ADC Analog Input block (not recommended)
Simulink® Real-Time™ Library of Drivers No Longer Recommended for Use
Block Output Data Type
Enter the Carrier ID of the IP carrier board into which the IP module is plugged.
To use an IP module, it must be physically plugged into an IP carrier board and the model must contain a block representing this carrier board. Each carrier block has a Carrier ID parameter, which must be set to a number not shared by other carrier board block in the model.
Select the slot on the carrier board into which the IP-16ADC module is plugged. Different carrier boards can have different slot capacities.
Enter a vector of numbers between 1 and 16. The channel numbers can occur in arbitrary order. For example, to use the first and third analog output (A/D) channels, enter
Number the channels beginning with 1 even if this board manufacturer starts numbering the channels with 0.
Enter a range code for each of the channels in the channel vector. The range vector must be the same length as the channel vector. This board allows the range of each channel to be different.
The following table is a list of the ranges for this driver and the corresponding range codes.
Input Range (V)
-10 to +10
-5 to +5
0 to 5
0 to 10
Range codes -10 and -5 specify differential channels, which
each use two pins on the I/O cable. Range codes 10 and 5 specify single-ended
channels, which each use only one pin. Certain combinations of channel
numbers and range codes can refer to conflicting physical I/O pins
and will cause an error of the form "Bipolar channel
Y use the same I/O pins".
Consult the section "I/O Pin Wiring" in the IP-16ADC User's Manual
as you select the channel and range vectors to avoid this.
Enter the base sample time or a multiple of the base sample
-1 means sample time is inherited).