IP-Synchro/Resolver block (not recommended)
Simulink® Real-Time™ Library of Drivers No Longer Recommended for Use
Block Output Data Type
Synchro or Resolver
angle in radians
Enter the Carrier ID of the IP carrier board into which the IP-Synchro module is plugged.
To use an IP module, it must be physically plugged into an IP carrier board and the model must contain a block representing this carrier board. Each carrier block has a Carrier ID parameter, which must be set to a number not shared by another carrier board block in the model.
Select the slot on the carrier board into which the IP-Synchro module is plugged. Different carrier boards can have different slot capacities.
Enter a vector with one or two elements to select the Synchro/Resolver input channels you use with this block. 1 represents channel A and 2 represents channel B. This driver allows the selection of inputs in either order.
For example to use channels A and B in that order, enter
This must be a scalar or a vector the same length as the channel vector. For each input channel it specifies a precision of either 10, 12, 14, or 16 bits. If the Automatic precision parameter is set, then the selected precision for each channel will be used for the entire run. Otherwise it merely specifies the initial precision.
Select this check box to have the IP-Synchro automatically change its precision (resolution) to track the input velocity.
This option selects the output status format.
position — Output position
position and status — Output
position and status
Enter the base sample time or a multiple of the base sample
-1 means sample time is inherited).