Speedgoat IO301 PCI Setup block
The Speedgoat IO301 PCI Setup block performs the setup and configuration to use the Speedgoat IO301 board.
The Speedgoat FPGA I/O board block descriptions are for informational purposes only. The HDL Coder™ HDL Workflow Advisor uses these blocks to generate a Simulink® Real-Time™ interface subsystem. The subsystem mask controls the block parameters. Do not edit the parameters directly.
Simulink Real-Time Library for FPGA
Enter a character vector to identify the model and subsystem containing the Setup block.
Select this check box for the FPGA to execute only when the real-time application is running.
Clear this check box for the FPGA to start immediately after the real-time application is loaded.
Select this check box for the FPGA to reset the initial state of the FPGA variables and registers to the default state on startup. Takes effect only when you select the check box Run FPGA only when Simulink Real-Time runs.
Clear this check box for the FPGA to retain the end state of the previous execution. To return to the initial state, download the model to the target again and restart the simulation.
The default setting is
Enter a number between
The maximum number of allowed boards is 8.
If only one board of this type is in the Speedgoat target machine,
-1 to locate the board.
If two or more boards of this type are in the Speedgoat target
machine, enter the bus number and the PCI slot number of the board
associated with this driver block. Use the format
To determine the bus number and the PCI slot number, type:
tg = slrt; getPCIInfo(tg, 'installed')