Systran SC150 write block (not recommended)
Simulink® Real-Time™ Library of Drivers No Longer Recommended for Use.
To open this library, type
xpcobsoletelib in the Command
Before you begin to configure this block, be sure that you have a predefined shared memory partition structure. The SC150 write block requires this structure to specify how Simulink signal values are mapped in the shared memory. It also uses this structure to determine the total size and address of the shared memory. See Create Curtiss-Wright Shared Partitions.
Enter the name of the predefined shared memory partition structure. The block uses this structure to specify how Simulink signal values map into shared memory.
Select this check box to monitor the status of the Systran® Scramnet
board CSR1 register modes. The enabled port is of type
Enter the base sample time or a multiple of the base sample
-1 means sample time is inherited)
If only one board of this type is in the target computer, enter
locate the board.
If two or more boards of this type are in the target computer, enter the bus number and the
PCI slot number of the board associated with this driver block. Use the format
To determine the bus number and the PCI slot number, type:
tg = slrt; getPCIInfo(tg, 'installed')