PD2-MFS 16-Bit Series Analog Input block
Simulink® Real-Time™ Library for UEI
I/O Module Input
Block Output Data Type
Select the specific board type from the list provided.
Enter a vector of numbers to specify the input channels. For example, use the first and third analog input (A/D) channels, enter
The channel numbers can occur in arbitrary order. Number the channels beginning with 1 even if this board manufacturer numbers them beginning with 0. The maximum allowable channel number is 4, 8, 16, or 64 depending on the board type.
Enter a vector of numbers to select the gains for each of the channels. Available gains vary depending on board type. MF PGL gains may be set to 1, 10, 100, or 1000. MF PGH gains may be set to 1, 2, 4, or 8. MF DG-option gains may be set to 1, 2, 5, or 10.
This vector must be the same length as the channel vector. It contains values of 0 or 1. If 1, the corresponding channel has a longer settling time. This is useful when using a high gain such as 100 or 1000.
Select the voltage range from the list provided. This applies to all channels.
From the list, select one from the following list of input coupling modes:
Refer to the UEI PowerDAQ documentation for input connections.
Enter the base sample time or a multiple of the base sample
-1 means sample time is inherited).
If only one board of this type is in the target computer, enter
locate the board.
If two or more boards of this type are in the target computer,
enter the bus number and the PCI slot number of the board associated
with this driver block. Use the format
To determine the bus number and the PCI slot number, type:
tg = slrt; getPCIInfo(tg, 'installed')