Documentation

Test 7: Execute Real-Time Application

This test executes a real-time application (slrttestmdl) on the target computer. If you change the slrttestmdl model start time to something other than 0, such as 0.001, this test fails. This change causes the test, and the MATLAB® interface, to halt. To address this failure:

  1. Set the slrttestmdl model start time back to 0.

  2. Rerun the test.

If this procedure does not solve your issue, see Real-Time Application Execution, Real-Time Application Performance, Real-Time Application Signals, and Real-Time Application Parameters in Troubleshooting in Simulink Real-Time. If you still cannot solve your issue, see Find Simulink Real-Time Support.

Was this topic helpful?