Why do I get an error related to openOCD when I use the support package for ST Discovery Board and perform a PIL in simulink 8.2 (R2013b)?
1 view (last 30 days)
Show older comments
MathWorks Support Team
on 30 Oct 2013
Edited: MathWorks Support Team
on 11 May 2021
Why do I observe the following error message when I try to simulate the 'stm32f4discovery_pil_block' model in PIL mode for the ST Discovery board?
Accepted Answer
MathWorks Support Team
on 11 May 2021
Edited: MathWorks Support Team
on 11 May 2021
This issue is observed because the ST Link USB driver for the Discovery board is not installed. One way to check if it is correctly installed (on a Windows 7 machine) would be:
- Ensure the device is switched on through the mini USB connection
- Go to Control Panel->Device Managers->STM32 ST Link->Properties
- if there are any issues, it should say the 'Device driver is not installed'.
To resolve this,
1. Download the ST link device driver for your platform from here:
2. Install the device drivers. During installation, note the path where the drivers are installed. For example:
C:\Program Files (x86)\STMicroelectronics\STM32 ST-LINK Utility\ST-LINK_USB_V2_Driver
3. Now go back to STM32 ST Link -> Properties in Device Manager and select 'update driver'.
4. Manually provide the installation path for the driver.
Once you have updated the driver, you should be able to run the PIL simulation fine.
0 Comments
More Answers (0)
See Also
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!