How to simulate a complex-valued space state system in simulink or by command?
19 views (last 30 days)
Show older comments
I have a complex-valued discrete space-state LTI system, where A belongs to C^n space and B,C,D to the R^n space, I need to simulate its response and I have tried to use lsim to do it, but it says it has problems with complex values as well as in simulink.
Someone has asked this question before and he has been recommended to use ltitr command, I have tried to use but inmediatly it says that "Matrix dimensions must agree". My matrices are,
I have a closed loop matrix (phi_clamp) which I construct by using a controller which is [XOUT 0]; and then I construct my space-state system which I need to simulate (sys_clamp).
phi_clamp=phiamp+gammaamp*[XOUT 0];
sys_clamp=ss(phi_clamp,gammaamp,Cc,Dd,h);% needs to be simulated
sys_clamp =
a =
x1 x2 x3
x1 0.364-0.0489i 0.771+0.0254i 0.00995
x2 -1.28-0.0988i 0.538+0.0514i 0.01
x3 -1.3-0.0998i -0.467+0.0519i 0
b =
u1
x1 0.49
x2 0.99
x3 1
c =
x1 x2 x3
y1 1 0 0
d =
u1
y1 0
Sample time: 1 seconds
Discrete-time state-space model.
By other hand to simulate with ltitr command what I have done is:
Xsim=ltitr(phi_clamp,gammaamp,U);
and I have use an U which is
t=0:h:50;
U=0.5*square(t/10,50)
because it says that it should be ltitr(A,B,U), but it says that "Matrix dimensions must agree". So what is wrong?
To simulate via simulink I have used a discrete space-state block with phiamp, gammaamp, C and D and my controller as a gain, it shows problems inside the block because of the complex values, the question here is should I change a parameter of the block or a simulation parameter, or what?
0 Comments
Accepted Answer
Azzi Abdelmalek
on 14 Jan 2014
Edited: Azzi Abdelmalek
on 14 Jan 2014
a=[ 0.364-0.0489i 0.771+0.0254i 0.00995
-1.28-0.0988i 0.538+0.0514i 0.01
-1.3-0.0998i -0.467+0.0519i 0]
b=[0.49;0.99;1]
c=[1 0 0]
d=0
t=0:h:50;
U=0.5*square(t/10,50)'
xsim=ltitr(a,b,U)
U should be a column vector
Or, you can also use lsim
system1=ss(a,b,c,d,1)
[output,time,state2]=lsim(system1,U,t)
3 Comments
Saveez Sheikh
on 13 May 2020
Can you please tell the how could I realize a complex statespace system in Simulink?
More Answers (0)
See Also
Categories
Find more on Time and Frequency Domain Analysis in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!