unable to view content of lookup table due to error

As can be seen from the attached picture I went from the block in fig A to B and finally entered subsystem C. The subsystem in C is suppose to have a 2D table that contains exhaust gas temperature for different speeds and torques (row and column header). But sadly i am unable to view the cells due to the error shown in lookup table editor (Present in figure E

). The error message is " Error occurs while retrieving data, check the selected block's parameter setting. Lookup table(2-D)block (mask) does not have a parameter named 'Table' "

How do i overcome this error to be able to view the cell contents?