Info
This question is closed. Reopen it to edit or answer.
How can i give analog input to CAN block?
1 view (last 30 days)
Show older comments
I am using the demo model of CAN communication using command "demoVNTSL_CANCommunication". It only gets discrete input. I have given sine wave with ADC and zero order hold, and it is working fine. but i have to use it with battery charging and discharging voltage and i am using battery model using command "power_battery". now when i attached the charging voltage with ADC and zero order hold and give it to CAN block as input, it gives me error that "The block diagram 'demoVNTSL_CANCommunication' uses bus signals. However, the 'Mux blocks used to create bus signals' diagnostic is not configured to 'error'. To prevent modeling errors:
(1) Open Upgrade Advisor and run the 'Check for Mux blocks used to create bus signals' check. (2) Follow the recommendations from this check to make your model compliant."
need help.
0 Comments
Answers (0)
See Also
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!