Dalsa Genie camera hardware trigger problem with imaqtool: logging frame 2
2 views (last 30 days)
Show older comments
Hi, I am using a Dalsa Genie camera (gigE) via ethernet and would like to use MATLAB and the image acquisition toolbox to record movies. I want to use a hardware trigger to start acquisition and log the movie to disk. With a manual trigger, everything works fine, but once I change to hardware triggering, MATLAB seems to get stuck: It recognises the hardware trigger I send, but it does not acquire several frames, the message in the imaqtool GUI is 'logging frame 2'. It does log a file to disk, but the file does not contain a movie.
Any ideas and comments would be greatly appreciated! Thank you, Charlotte
2 Comments
Iven Yu
on 19 Apr 2018
Hi Charlotte, I am encountering the same issue that you had. I was wondering if you have ever figure it out and could share some solutions to this issue? Many thanks!
Charlotte Arlt
on 19 Apr 2018
Hi Iven, I recall that in the end I had to install the vendor-specific software and change some settings in there to enable hardware triggering. I hope that helps!
Answers (0)
See Also
Categories
Find more on DALSA Sapera Hardware in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!