Problem displying voltage/current when using Phasor type, /FFT problem

Hello, I'm modeling a wind farm connected to an electrical grid and have to analyse power quality problems caused by the wind farm. When starting my model i made partial use of the example that was given with the block (Wind farm with a DFIG, or however it is called). Since I used this block I am forces to use the powergui in Phasor Type mode and i have no experience with that.

Now here is my question.

Is it possible display voltage/current measurement onto a scope so that it looks sinusoidal/harmonic, or is it in Phasor type only possible to display magnitude and phase. I tried to use the sequence analyser to break the voltage (lets say Vabc) into magnitude and phase, and using math operation blocks make v(t)=sqrt2*mag*sin(phase*t+fi) to get something with a harmonic look (I took the time out of a clock). The problem is the sine that i get is nowhere near the frequency i should get (60 Hz). I want to get the signal to use the powergui FFT to make a harmonical analysis, compute THD, ect.

If anybody with experience using phasor type in matlab could help I would be very thankful.