Asked by ws
on 22 Dec 2011

Hi all

There is a function called hist(), but if I want to plot a graph without using hist() command, how to plot a graph? I means using command to do the job same as hist().

Thank you.

*No products are associated with this question.*

Answer by Naz
on 22 Dec 2011

Accepted answer

It depends on how you want to bin your data and what kind of data you have.

The idea of hist function is similar to stacks of coins: Let's say you have a bag of coins and after you separate them by values and stack on one another, you will get different heights. The hist function does the same.

data=[1 3 5 7 4 8 0 1 3];

If you want to distribute your data into 10 bins, you would create a new array of size 10:

histArray=zeros(1,10); % prealocate x=0:1:9; then, you would run a forloop to count how many times you encounter in a particular value:

for n=1:length(data) histArray(1,data(n)+1)=histArray(1,data(n)+1)+1; % every time you meet the particular value, you add 1 into to corresponding bin end bar(histArray)

There could be another case. Let's say you want to distribute your data into 5 bins only (0 and 1 go in the 1st bin, 2 and 3 go in the 2nd...). In this case, you would run the same loop but with more complicated conditioning:

histArray=zeros(1,5); %prealocate x=0:2:8 % create bin numbers for plot for n=1:length(data) histArray(1,floor(data(n)/2)+1)=histArray(1,floor(data(n)/2)+1)+1; % every time you meet the particular value %you add 1 into to corresponding bin end bar(x,histArray)

You can design your own hist function to fit you needs

ws
on 22 Dec 2011

thanks, this is what i'm looking for.. :)

Answer by Adrian Lukasik
on 13 May 2015

Edited by Adrian Lukasik
on 13 May 2015

hello I have another problem. The same thing, but in 3D: There is a function called hist3(), but if I want to plot a graph without using hist3() command, how to plot a graph? I means using command to do the job same as hist3(). I have matrix b, 2x1000, and the task about making histogram plot without hist3() function.

Thank you.

Walter Roberson
on 13 May 2015

You should open a new Question for that.

Once you have the counts for each grid-point, use bar3()

Related Content

MATLAB and Simulink resources for Arduino, LEGO, and Raspberry Pi

Learn moreOpportunities for recent engineering grads.

Apply Today
## 0 Comments