suppose i carry out a simulation for 10 seconds and i get satisfactory results. now i run the simulation for 20 sec, it again starts from 0. is there anyway that the i continue from 10s and save run time.
No products are associated with this question.
Direct link to this answer:
Please take a look at this page in the Simulink documentation:
MATLAB and Simulink resources for Arduino, LEGO, and Raspberry Pi
Opportunities for recent engineering grads.
New to MATLAB?
Unable to complete the action because of changes made to the page. Reload the page to see its updated state.
Choose your country to get translated content where available and see local events and offers. Based on your location, we recommend that you select: .
You can also select a location from the following list:
See all countries