MATLAB and Simulink resources for Arduino, LEGO, and Raspberry Pi

Learn moreOpportunities for recent engineering grads.

Apply Today**New to MATLAB?**

Asked by Muruganandham Subramanian
on 26 Mar 2012

Hi friends,

I am doing the fault location using wavelets. For that, am having two waveforms (aerial mode voltage(Va) & ground voltage (Vo)).

If, am creating fault,@0.5s, I need to find out the disturbance time of both waveforms, bcos both waveforms will take some time to respond.

Thanks!!!

*No products are associated with this question.*

Answer by Wayne King
on 26 Mar 2012

For this, you will want to use either the continuous wavelet transform (cwt or cwtft), or a nondecimated wavelet transform (ndwt, or swt).

Muruganandham Subramanian
on 26 Mar 2012

First of all,

Thanks for ur reply wayne. Any of the wavelets method is ok for me.

Wayne King
on 26 Mar 2012

Then feel free to use any of those methods, see the documentation for examples. You should be able to localize the disturbances at small (fine) scales.

## 1 Comment

## Muruganandham Subramanian

Direct link to this comment:http://www.mathworks.com/matlabcentral/answers/33475#comment_70391

For e.g. If i take sine wave input (it may have some small disturbance), after creating the fault @0.5s,that waveform will be more distorted than normal,that particular time i need to measure precisecly.