simulink-using threshold
25 views (last 30 days)
Show older comments
Hi,
I am trying to simulate a case in simulink where i need to set the output to 1 when the input is between two threshold levels, otherwise the output is 0. I tried to use relay block, but it incorporates hysteresis which i do not want. PLEASE GIVE ME A SOLUTION.
1 Comment
TAB
on 6 Apr 2012
Is there any problem with using comparator block (<=, >=) along with switch block to implement the logic ?
Answers (2)
mahjoub el attar
on 5 Apr 2012
The answer is in your question. Don't use Relay block but Threshold Block... Friendly.
2 Comments
mahjoub el attar
on 5 Apr 2012
I did it before but I just don't remember.I need to check my old models on my own laptop tonight.
I hope you'll get a faster answer.
See Also
Categories
Find more on Subsystems in Help Center and File Exchange
Products
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!