Curve Fitting Toolbox error before starting
8 views (last 30 days)
Show older comments
Hi, I'm trying to use the Curve fitting Toolbox but I've got an error when I type the command cftool. I think is because my matlab is old and doesn't support the ~ operator, because when I go to the error points to it in the function code. But I'm not such experienced user and I don't know how to solve the problem. Changing it by 'trash' didn't help.
I'll very much appreciate any suggestion. Thank you G.
1 Comment
Jiro Doke
on 20 Mar 2011
That doesn't make sense. Are you sure you installed the same version of Curve Fitting Toolbox as the version of MATLAB? Then that kind of error should not happen.
The only thing I can think of is that you have an old version of MATLAB, and you're trying to run functions from a newer version of Curve Fitting Toolbox. You should install the version of the toolbox for your MATLAB. You can't just copy (or run) any version. Each toolbox is meant to run on the same version of MATLAB.
Answers (2)
Andreas Goser
on 20 Mar 2011
In order to find out the toolbox is installed correctly:
ver
should return MATLAB as well as Curve Fitting toolbox with the same release, e.g.:
MATLAB Version 7.11 (R2010b)
Curve Fitting Toolbox Version 3.0 (R2010b)
And also verify correct licensing:
license('test','Curve_Fitting_Toolbox')
This should return 1.
0 Comments
Guisella Gacitúa
on 20 Mar 2011
8 Comments
Walter Roberson
on 21 Mar 2011
Okay, so what you have is known to be fairly precise where you have it -- but is there a good model for the transitions between the locations? If not then there isn't anything that can be done.
See Also
Categories
Find more on Get Started with Curve Fitting Toolbox in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!