PIL "rtiostream interface" timeout, f28377d, c2000

7 views (last 30 days)
Timothy Scott
Timothy Scott on 8 Sep 2019
Moved: DGM on 2 Dec 2023
I am able to deploy code generation onto the DSP (f28377d controlCARD R1.1).
However I can't execute a Processor-in-the-loop simulation. The serial comms seems to be issue.
I get the below error after program has been downloaded to target.
Can I get some suggestions on how to troubleshoot the issue?
Thanks v. much
The timeout of 10 seconds for receiving data from the rtiostream interface has been exceeded. There might be multiple reasons for this failure.
You should:
(a) Check that the target hardware configuration is correct, for example, check that the byte ordering is correct.
(b) Confirm that the target is running.
(c) Consider the possibility of application run-time failures (e.g. divide by zero exceptions, incorrect custom code integration, etc.).
Note (c): To identify possible reasons for the run-time failure, consider using SIL, which supports signal handlers and debugging.
If you cannot find a solution, consider using the method setTimeoutRecvSecs of rtw.connectivity.RtIOStreamHostCommunicator to increase the timeout value.
  3 Comments
Meenakshi RM
Meenakshi RM on 10 Jun 2023
Hi,
May I know how you solved this problem?
Thanks,
Meenakshi
MERIEM
MERIEM on 2 Dec 2023
Moved: DGM on 2 Dec 2023
Ihave the same problem could any on e solve it

Sign in to comment.

Answers (1)

Venkatesh Chilapur
Venkatesh Chilapur on 9 Sep 2019
Hi,
Please contact :
Regards,
Venkatesh C

Products


Release

R2019a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!