Failure while using function pem of system identification - plot compare shows step at the beginning of the signal trend
1 view (last 30 days)
Show older comments
Hey,
I’m using the function pem to identify a process. When I plot the result with function compare the plot shows a step at the beginning. Does anybody know why this happens?
I used the code:
Ts=1;
z_mittel = iddata(y,u,Ts);
ze_mittel=z_mittel(1:1040);
zv_mittel=z_mittel(1040:2201);
P1DI_mittel=pem(ze_mittel,'P1I');
compare(z_mittel,P1DI);
And the plot result is:
Why do I get the step at the beginnig of the plot? I think as a result of this step the toolbox doesn't provide the best parameters.
Thanks for your help!
0 Comments
Accepted Answer
Rajiv Singh
on 21 Dec 2012
Difficult to say without looking at the data, but try using zero initial conditions for the comparison:
compare(z_mittel,P1DI, 'init', 'zero');
You may observe that the overall fit is even worse. But then that is just saying that you do not have a good model.
More Answers (0)
See Also
Categories
Find more on Linear Model Identification in Help Center and File Exchange
Products
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!