MATLAB and Simulink resources for Arduino, LEGO, and Raspberry Pi

Learn moreOpportunities for recent engineering grads.

Apply Today**New to MATLAB?**

Asked by Arun Badigannavar
on 7 Jan 2013

How to send data to workspace continuosly whenever my simulink model has been paused by below code,,I am using a simple constant block and to workspace block

tic open_system(''); for i=1:1:10 set_param('SampleTest','StopTime', sprintf('%d',i)); set_param('SampleTest', 'Simulationcommand', 'start') pause(1) set_param('SampleTest', 'Simulationcommand', 'update') set_param('SampleTest', 'Simulationcommand', 'continue') end toc

Answer by Kaustubha Govind
on 7 Jan 2013

Accepted answer

Please see the second paragraph in my answer here for an explanation of what you're seeing. If you'd like your workspace to be updated immediately, you might need to write your own MATLAB code to do this. You can follow the technique described in Access Block Data During Simulation to run your MATLAB code as soon as a new output value becomes available.

Arun Badigannavar
on 11 Jan 2013

I have found the solution,,,I avoided paassing variables value to workspace,,,rather am directly calling the values to next model wher i require them,,thanks for ur help i learnt usefull things

## 2 Comments

## Arun Badigannavar (view profile)

Direct link to this comment:http://www.mathworks.com/matlabcentral/answers/58144#comment_121191

I am trying this but data will come to base workspace oly after my code finishes 10 steps

## Azzi Abdelmalek (view profile)

Direct link to this comment:http://www.mathworks.com/matlabcentral/answers/58144#comment_121487

Do you mean after 10, itterations?