How to run simulink through dSPACE(DS1104) without control desk?

can any one help me how to run the simulink through dSPACE (DS1104) by changing external mode and to connect target link after build code, so as verify the signals through simulink scope block and vary the parameter using slider gain like RTW with out going control desk software.

if possible mean give me the procedure.

thanks in advance..

Reg,

R.Manikandan,M.E.,(Ph.D)., AP / Department of EEE, The Kavery Engineering College, Mecheri (po), Salem(dt), pin:636453 Tamil Nadu, India. Cell: 9944270473 Email: [e-mail]

Answer 1

Try to build your model, then set your system target file to rti1104, and click on connect to target, then start simulation. I 've never did it before, I will try it tomorrow (I am working on the same card, and always used Controldesk). To configure your model, I think you can do it with rtwinconfigset (you are using with real time windows target)

thanks for your interest, me too the same idea. if you complete give me the procedure. i,m also trying to do

i did what you said but it does not work so did you find any solutions?

me to same problem, so how to solve this problem? where we get solution. i plan to contact dSPACE guys who's provided us to DS1104 kit. you to try your service provider, if you find solution share me..