Asked by Utkarsh Deshmukh
on 21 Jan 2013

how does matlab implement the command: imresize(<image>,<scaling factor>,'bicubic');

the other types of interpolations are easy to understand and implement. but in case of bicubic, when the scaling factor is less than 1, it does the anti-aliasing filter operation. how does this operation work?

*No products are associated with this question.*

Answer by Image Analyst
on 21 Jan 2013

Accepted answer

2 points define a line, 3 define a quadratic, and 4 define a cubic. So if you have just the two adjacent pixels, you can do a bilinear interpolation, a bicubic interpolation uses two pixels on each side, in each direction. Same things as bilinear, just using 4 pixels instead of two to get the value of the pixel "in the middle". Not sure how it does antialiasing - perhaps it blurs it a little after the interpolation. Why do you ask?

Utkarsh Deshmukh
on 21 Jan 2013

Utkarsh Deshmukh
on 21 Jan 2013

MATLAB and Simulink resources for Arduino, LEGO, and Raspberry Pi test

Learn moreOpportunities for recent engineering grads.

Apply Today
## 0 Comments