Using counter on NI card in 'Buffered Period Measurement' mode
1 view (last 30 days)
Show older comments
Hello,
I want to use a one of the two clocks of an NI USB-6211 card in what is called Buffered Period Measurement ( 8-7 ).
Is this possible? Up till now i only was able to set the counter to 'Edge Counting', 'PulseWidth' I cannot use, because I cannot control the period the gate signal is set to high.
Thank you for any input!
Regards, Manuel
0 Comments
Answers (0)
See Also
Categories
Find more on Data Acquisition Toolbox Supported Hardware in Help Center and File Exchange
Products
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!