Simulink split Output Signal, Running time of Subsystem
1 view (last 30 days)
Show older comments
Good Afternoon,
I am using Simulink to simulate an electric circuit.
I have to phases, a charge and a discharge-phase, from which I monitor voltage over time. The Output is e.g. a signal: 1x600
To separate the two phases i use an enable-subsystem depending on the state (charge / discharge). Sadly, the output of the enable-subsystem is the same as the complete system: e.g.
- charge = 1x600 with values "0" beginning from e.g. 200
- discharge = 1x600 with values "0" before e.g. 200
I would like to have:
- charge = 1x200
- discharge = 1x400
Does anyone know how i can resolve this? I kind of need the subsystems to have different running-times. Meaning, the running time of the discharge-subsystem should start from zero once it is enabled.
Best Regards, Florian
0 Comments
Answers (0)
See Also
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!