Send buffered data to the specified serial port.
Enter the number of the serial port. For Arduino Mega 2560,
enter 0 - 3. For Arduino Uno, enter 0. One Serial Transmit blocks
using the same port is allowed in the model.
This block writes a vector of bytes read through the blocks
input port to the specified serial Arduino port. Ports 0, 1, 2, and
3 are available.
Multiple Serial Transmit blocks using the same port is allowed
in the model.
This block uses the Serial.write function from the standard
Input Port: - Data: uint8
If you run your model on target hardware, this block uses the
data it receives through the block inputs. If you simulate your model
without running it on the target hardware, this block does not do
anything. See TBD.
Send Buffered Data to Serial Port
Use the Serial Transmit block to send buffered
data to a serial port.
Install support for Arduino using the Target Installer,
as described in TBD
(Perform the second step — TBD)