Hey ahmet nas, my teacher asked me to run this model without SMO. This means the rotor angle and the motor's speed must be feedback directly from the output of motor. I ran the simulation but it was not right. Can you run simulation the model without SMO and have a right result? And you can spend it to my mail:firstname.lastname@example.org. Thank you very much!!!
hello..i would like to ask a very basic question. In this schematic diagram you feedback the inverter output currents..but i think we should feedback the ipmsm phase currents rather than the inverter..plz would you like to tell me about it..thanks
06 Nov 2014
The simulink model of current controlled PMSM drive with constant torque control id=0.
While running the simulation, the following error message is shown:
"At time 2.4999992682880994E-5, simulation hits (1000) consecutive zero crossings. Consecutive zero crossings will slow down the simulation or cause the simulation to hang. To continue the simulation, you may 1) Try using Adaptive zero-crossing detection algorithm or 2) Disable the zero crossing of the blocks shown in the following table:"
Could you please explain the solution and cause of this error?