Thread Subject: Simulink error in a huge model

The model is about 20Mb.

In compiling, there is following message:
"Invalid setting for output port dimensions of 'Bus Creator'. The dimensions are being set to 1. This is not valid because the total number of input and output elements are not the same."

The connection of signals are fine. The names are consistent. what will be the potential reason and appropriate methodology to handle this error?

Thanks,
Hong

Hong,

I have the following questions for you:

1. Which version of MATLAB are you using?
2. Do you have nested buses of mixed type - virtual and
non-virtual buses?

Divya

Hong,

I have the following questions for you:

1. Which version of MATLAB are you using?
2. Do you have nested buses of mixed type - virtual and
non-virtual buses?

Divya

"Divya Paul" <dp68@drexel.edu> wrote in message
<f9jr9c$50e$1@fred.mathworks.com>...
> Hong,
>
> I have the following questions for you:
>
> 1. Which version of MATLAB are you using?
> 2. Do you have nested buses of mixed type - virtual and
> non-virtual buses?
>
> Divya

Hi,

I have same problem,

Invalid setting for output port dimensions of 'Bus
Creator'. The dimensions are being set to 16. This is not
valid because the total number of input and output
elements are not the same.

I am using MATLAB R2006a Simulink 6.4.

Thanks,
Mahesh

Hi, Divya,

My version is 7.0.4 sp2. the source of problem is
identified as the lack of dimension definition of some
signals, for instance, use 'Ground' blocks as the source.
Does old version have this problem with 'ground' block?

"Mahesh " <MaheshGhivari@Eaton.com> wrote in message
<faglia$gtp$1@fred.mathworks.com>...
> "Divya Paul" <dp68@drexel.edu> wrote in message
> <f9jr9c$50e$1@fred.mathworks.com>...
> > Hong,
> >
> > I have the following questions for you:
> >
> > 1. Which version of MATLAB are you using?
> > 2. Do you have nested buses of mixed type - virtual and
> > non-virtual buses?
> >
> > Divya
>
> Hi,
>
> I have same problem,
>
> Invalid setting for output port dimensions of 'Bus
> Creator'. The dimensions are being set to 16. This is not
> valid because the total number of input and output
> elements are not the same.
>
> I am using MATLAB R2006a Simulink 6.4.
>
> Thanks,
> Mahesh
>
>
>
>