Thread Subject: switched reluctance generator

I need some help for modelling of switched reluctance generator in MATLAB - simpower system (R 2008 a / R 2008 b). The model for SRM is available in this version.How to go about for SRG From SRM.

"Susitra " <suchithradhanrah@yahoo.co.in> wrote in message <h8v60k$9vf$1@fred.mathworks.com>...
> I need some help for modelling of switched reluctance generator in MATLAB - simpower system (R 2008 a / R 2008 b). The model for SRM is available in this version.How to go about for SRG From SRM.

hai susitra ,
            if you want the modeling check this link

http://scholar.lib.vt.edu/theses/available/etd-22198-124235/unrestricted/etdtext.pdf

MODELING AND ANALYSIS OF A DC POWER DISTRIBUTION
SYSTEM IN 21ST CENTURY AIRLIFTERS
by
Konstantin P. Louganski
Thesis submitted to the faculty of the
Virginia Polytechnic Institute and State University

go through this paper once

regards
ramana

"Susitra " <suchithradhanrah@yahoo.co.in> wrote in message <h8v60k$9vf$1@fred.mathworks.com>...
> I need some help for modelling of switched reluctance generator in MATLAB - simpower system (R 2008 a / R 2008 b). The model for SRM is available in this version.How to go about for SRG From SRM.

hai susitra,
         go through these references
1..... C. R. Elliott, J. M. Stephenson, and M. J. McClelland, “Advances in Switched Reluctance Drive System Dynamic Simulation.” EPE 1995 Annual Meeting Proceedings, pp. 622-626.
2.......A. V. Radun and Y. Q. Xiang, “Switched Reluctance Starter/Generator System Modeling Results,” SAE Technical Papers, 1995, Paper No. 951407.