Thread Subject: MZDDE toolbox for Zemax

Hello,

I am trying to use Matlab to control Zemax using the MZDDE
version of Matlab 2009a
version Zemax October 12, 2009

I am running in full NSC mode. I can intialize the the dde link, get the positon of an object in the NSC editor, change the object tilt. However, when I try to push the lens from Matlab back to Zemax I get a time out error. I have set the allow extensions to push object click box but this did not seem to do anything. I am not sure why I get the error. Not I can push the changes when I am only using the LDE but not the NSC editior. Is there a command I am missing?


Mike