Thread Subject: Dlink DCS-5300 camera conf.

Hi
I have a Dlink camera, a DCS-5300 and I want to used it with the image adquisition toolboox. Im concerned about the tilt and pan that the camera has. Someone know if it is possible to use to it with matlab ??
Also Im want to know if it is possible to get snaps from the camera like I do it with my little Microsoft webcam using getsnapshot and videoinput for config.
Im using R2009a

Cristobal wrote:
> Hi
> I have a Dlink camera, a DCS-5300 and I want to used it with the image adquisition toolboox. Im concerned about the tilt and pan that the camera has. Someone know if it is possible to use to it with matlab ??
> Also Im want to know if it is possible to get snaps from the camera like I do it with my little Microsoft webcam using getsnapshot and videoinput for config.
> Im using R2009a

Hi Cristobal,

 From looking at the data sheet it is not clear that this camera
supports VFW or WDM which would make it accessible through the winvideo
adaptor in the toolbox.

I would encourage you to check with the manufacturer to see if they have
VFW or WDM drivers that work with software such as AMCAP. For more
information, see:

http://www.mathworks.com/products/imaq/supportedio13875.html

Mark