Professional Interests: Aeroelasticity, Control Systems, Hydraulics
Top 10% contributor
Frame an equation between two of the points of the form y=mx+c. then replace x with the x-cordinate of the point to be checked, ...
Answered 2 years ago
I think this would work elegantly. But I don't know if this would take up alot of time/memory for your purposes.
First of all your velocity profile is not symmetric about y=0, so if you rotate that graph by 180, you will not get a closed sur...
Answered 3 years ago
i have recently made a simulink model of a mechanical system, though complex in nature, but basically it is a second order ODE.
Asked 3 years ago
suppose i carry out a simulation for 10 seconds and i get satisfactory results. now i run the simulation for 20 sec, it again st...
Asked 4 years ago
I have prepared a simulink model of a system which is a multiple degree of freedom system, has different feedback gain associate...
4 years ago
I have a model of a system which takes state variable z as one of the inputs, and gives the time derivative zd as one of the out...
I am simulating the model for 2 seconds, but the scope shows a time history of 0.8 to 2 seconds only, even if i use the autoscal...
Here are two scopes of the same simulation run for different run times 50s and 100s. For 50 s, the concerned parameter remains c...
I was doing matrix operations using symbolics, I found out to my surprise, that the results where wrong and unrepeatable. Same o...
Asked 2 months ago
I have a model of a mechanical system in simulink, which has a lot of parameters which are NOT variables mathematically speaking...
Asked 2 years ago
I have a matrix whose smallest eigenvalue is positive but very close to zero (~ 1e-17). Theoretically, it should be a positive s...
Asked 8 months ago
3 years ago
Choose your country to get translated content where available and see local events and offers. Based on your location, we recommend you select United States from the following list:
See all countries