Community Profile

Gabriel Ortega Rosero


8 total contributions since 2013

Contact

Contributions in
View by

Question


I can`t use data acquisition toolbox, help
Hi, when I type the command "ver" in workspace's matlab, here appear that I have installed "Data Acquisition Toolbox Version 3.3...

3 years ago | 0 Answers | 0

0

answers

Answered
How to start using the Data Acquisition Toolbox?
Did you fix the problem? Happens the same with me, when I type "ver" appear that I have the data aquicisition toolbox, but I ca...

3 years ago | 0

Question


I can`t use data acquisition toolbox
Hi, when I type the command "ver" in workspace's matlab, here appear that I have installed "Data Acquisition Toolbox Version 3.3...

3 years ago | 2 Answers | 0

2

answers

Question


How to configure Simulink Arduino support package
Hi, I´m trying to do data adquisition with arduino in simulink, I configured the device and run the configurations (build the co...

3 years ago | 1 Answers | 0

1

answer

Responded


Re: how to make a delay in a "for" cycle?
Thanks you so much! The signal is a EMG signal, and have a range between 20 -300Khz.... I found another way to reach my objectiv...

3 years ago | 4747 views

Responded


Re: how to make a delay in a "for" cycle?
The device is a arduino one, do you know it? and the code inside it is this: int out1 = 0; void setup() { void loop() { The tim...

3 years ago | 4747 views

Responded


Re: how to make a delay in a "for" cycle?

3 years ago | 4747 views

Posted


how to make a delay in a "for" cycle?
Hi, I need to do matlab data acquisition, but I need control the rate and amount of data stored in a vector. I made a "for cycle...

3 years ago | 4747 views