Community Profile

photo

Shengnan Li


Franklin Electric

Last seen: 1 year ago |  Active since 2016

Followers: 0   Following: 0

Message

Statistics

  • First Review
  • Thankful Level 1

View badges

Feeds

View by

Question


Can someone provide a peak current mode controlled buck or boost circuit model in simulink?
Does anyone have a peak current mode controlled buck or boost or other power circuit model?Save me some time. Thanks a lot.

3 years ago | 0 answers | 0

0

answers

Question


how to control Ball valve input signal s
The ball valve model has an input signal s to control ball displacement. I don't understand how it is controlled. for example, i...

7 years ago | 1 answer | 0

1

answer

Question


signal input of orifice/valve
How to specify this input? Thanks,

7 years ago | 0 answers | 0

0

answers

Question


Why signal changes rise/fall time outside the subsystem block?
I have a subsystem that has a direct look up table in it. the output of this look up table is the upper one in the attached fig....

8 years ago | 0 answers | 0

0

answers

Answered
'to workspace' data length question
Thanks for answering my question. I finally figured out, it is the 'decimation' parameter. It was set to 5. when i changed to 1,...

8 years ago | 0

| accepted

Question


'to workspace' data length question
I specified the sample time for 'to workspace' block to be 10^(-5), but it saved only 20k data points, while it should be 100k d...

8 years ago | 2 answers | 0

2

answers

Question


how to get the average frequency for the hysteresis band control?
I am simulating a Direct torque control induction motor. Want to know the average frequency. How do i get it from the switching...

8 years ago | 1 answer | 0

1

answer

Question


Why I get different data from 'to workspace' and 'scope'
I have a switching signal, and a 'edge detector', try to count the pulses. The results from scope looks very good, the 'edge det...

8 years ago | 1 answer | 0

1

answer