Ninja

Active since 2014

Followers: 0 Following: 0

Message

Answered
Simulink: how to initialize the first state of an output function
ok, I just found it, it is just that atan function at start can process the division calculation 0 / 0, so i need to take into a...

5 years ago | 0

Question

Simulink: how to initialize the first state of an output function
Hello everyone, I guess my issue is quite simple but i didn't manage to find any good answer after looking for it. I am using...

5 years ago | 1 answer | 0

answer

Answered
how to plot different curves on a same graphic with a third axis
One little question about it: my data curves, despite the limit I set for each axes, go over the axis (as shown on the picture),...

6 years ago | 0

Answered
how to plot different curves on a same graphic with a third axis
Ok, i have managed to do it using plot3 function, but before, i needed to create a new vectors full of the rotational speed valu...

6 years ago | 0

Question

how to plot different curves on a same graphic with a third axis
Hello everyone =), Here is my problem: i have several FFT curves, all from 0 to 1200Hz calculated from experiment recorded d...

6 years ago | 2 answers | 0

answers

Answered
Simulink compiler issue with SDK 8 and Matlab R2013b on windows
Thank you for you answer A Jenkins, you're right, I will uninstall windows SDK8. But, is SDK 7.1 compatible with my windows 8...

10 years ago | 0

Question

Simulink compiler issue with SDK 8 and Matlab R2013b on windows
Hello, I have recently installed R2013b version of matlab on my new laptop with windows 8, and installed SDK 8. But when I t...

10 years ago | 2 answers | 0

answers