Community Profile

photo

Antti Wredfors


ABB Oy Drives

Last seen: 8 months ago |  Active since 2015

Message

Statistics

  • First Review
  • Revival Level 1
  • Thankful Level 1
  • First Answer

View badges

Content Feed

View by

Answered
ZedBoard support package in a different module
The carrier board is needed to boot from sd card. TE0720 will work, but there are different models. Try to choose most similar o...

5 years ago | 0

Answered
ZedBoard support package in a different module
It will need some work, but it is possible. If the io is exactly same then it's quite easy to get running. Some work is needed i...

5 years ago | 0

Question


How to convert system.string to uint8?
I'm using .NET to read FTDI usb uart serial data. The following method: str = System.String('create a System.String...

6 years ago | 0 answers | 1

0

answers

Question


ZedBoard support package in a different module
Hello, I'm using now a Zedboard and it's support package. I would like to run hardware in the loop in a different platform, w...

7 years ago | 2 answers | 0

2

answers

Question


Worflow advisor tcl scripts generates error at programming phase
Hello, Advisor section "4.4 Program Target Device" will pick any device with xilinx or digilent interface and will cause prog...

8 years ago | 2 answers | 0

2

answers

Answered
zedboard fpga in loop
I have some diffuculties with new 2015b release too. It's a litle bit same like previous post. The tcl file will not download bi...

8 years ago | 1

Question


HDL Workflow advisor co-simulation to custom board, freerunning mode
Is there some way how to get custom Zynq board to freerunning mode with co-simulation? I do have now ZedBoard which runs co-si...

8 years ago | 1 answer | 0

1

answer