Image Acquisition Toolbox 3.2

Supported Hardware - DALSA Coreco

The table below lists the DALSA Coreco frame-grabber boards supported by the Image Acquisition Toolbox. For detailed information about a board listed here, visit the DALSA Coreco Web site.

Depending on the frame-grabber board, the Image Acquisition Toolbox requires either the Imaging Foundation Classes (IFC) version 5.8 or the Sapera LT version 6.12. For additional information refer to the troubleshooting documentation for DALSA Coreco software:

• Troubleshooting Coreco IFC Hardware
• Troubleshooting Coreco Sapera Hardware

To request support for a board not listed in this table, complete the Additional Hardware Interface Support form below.

DALSA Coreco

Supported Hardware
Bus/Form Factor	Product Name	Minimum Version Required
PCI	PC2-Camlink	IFC (version 5.8)
	PC2-Vision	IFC (version 5.8)
	PC-Camlink	IFC (version 5.8)
	PC-DIG	IFC (version 5.8)
	PC-RGB	IFC (version 5.8)
	PCVision	IFC (version 5.8)
	PCVisionPlus	IFC (version 5.8)
	PC2-Camlink	Sapera LT (version 6.12)
PCI-X	x64-AN Quad	Sapera LT (version 6.12)
	x64-CL Dual	Sapera LT (version 6.12)
	x64-CL Full	Sapera LT (version 6.12)
	x64-CL iPro	Sapera LT (version 6.12)
	x64-LVDS	Sapera LT (version 6.12)
PCI-Express	X64 Xcelera-CL PX4 Dual	Sapera LT (version 6.12)
	X64 Xcelera-CL PX4 Full	Sapera LT (version 6.12)
	X64-CL Express	Sapera LT (version 6.12)
	PC2-COMP Express	Sapera LT (version 6.12)

 

Request Additional Hardware Interface Support

*Indicates Required Information *Hardware Manufacturer Comments *E-mail (Format must be valid, e.g., name@yourdomain.com) We will not sell or rent your personal contact information. See our privacy policy for details.